P3 Gauges V3 OBD2 Multi-Gauge w/ Pre-Installed OEM Vent Trim, Red/White 2016-2019 Cadillac CTS-V

Features:

• Factory Vent Pre-Mounted for Gauge
• Red/White Gauge Display
• Plug and Play Install - Plugs Directly into the Factory OBD2 Port
• OEM Integration - installs in your vent for a sleek install while retaining air flow
• Versatility - Read Boost from Multiple OEM Sensors through OBD2 Port or Using Optional P3 Analog Boost Sensor
• Code Reading/Clearing - Read and Clear Diagnostic Trouble Codes (DTCs) on the Fly
• OEM Vent Option - P3 Installs the Display in an OEM Vent to Make Your Install Easier

P3 V3 Gauge Readouts:

• Ethanol (vehicle must be flexfuel equipped)
• Boost (through OBD2 port using OEM sensors or with P3 analog boost sensor)
• Coolant temperature
• Vehicle speed (can be calibrated in 1% increments from -9% to +20%)
• Intake air temperature
• Throttle angle
• Ignition timing
• Engine RPM
• Exhaust gas temperature
• Battery voltage
• Programmable shift light
• Analog input 1 (brown wire) can allow gauge to read any 0-5 volt linear output sensor
• Analog input 2 (blue wire) can allow gauge to read any 0-5 volt linear output sensor
• Acceleration timers (0-60mph/0-100mph/60-130mph)
• Braking timers (60-0mph/100-0mph)

P3 Gauges offer a multi-function gauge that gives you the information you need while maintaining a clean OEM look. Starting at a price competitive to single feature old-school needle gauges, they offer unmatched feature to price ratio.

Note: To use other OBD2 accessories with P3 Gauge plugged in, enter the "CONF" menu or set to d. Off to prevent interference.

Note: Ethonal reading occurs on gauges built after 7/1/2022, gauge will read on the very first startup. If Ethanol output is not initiated on vehicle, a factory reset of the gauge is required to initiate calibration.

Full Configuration Guide (opens in new tab): Click HERE

Vent Installation Instructions (opens in new tab): Click HERE

Part Number: L3P3CTR3+V