Soler Performance Ported Throttle Body, 103MM LS2 2005-2008 Corvette

Features:

• Wide-open throttle flow: 1600 +/- 50 SCFM @ 20” H2O at WOT
• Designed for drivability; no tune required (highly recommended for optimal performance)
• Max Area ETC scalar : 5396mm²
• Max Geometric/Flow Area: 7466mm² (do not use as area scalar in tune)
• Fully tested before shipping for sensor and motor operation, response time, and airflow.
• Body and Sensors calibrated as a match set, zero intrinsic calibration issues
• Porting Taper and Upstream Bore with Velocity Stack (Lip & Bore Reduction)
• 16 Ra Microinch, Diamond Polished Surface Finish (Lower Skin Friction)
• Dimpled Pattern on shaft trailing edge
• Dual-purpose hole pattern, the innermost part provides a direct fit to the MSD and all LT1/2/4 manifolds/superchargers, or aftermarket superchargers. The outermost provides a direct fit to the LT5 (ZR1) supercharger.

Benefits:

• Essential component in high-performance engine modification, with exceptional high flow capacity
• Lower weight to power ratio at part throttle, for a more nimble/spirited driving experience
• Linearization and smoothing of the curve for a more predictable response and crisper shifts
• Immediate response right off idling while keeping idling function undisturbed (No Hesitation/Stumble)
• Does not require tuning to run, but tuning is highly recommended for optimal performance
• No drivability, idle, tuning, or similar issues relating to similar-sized throttle bodies.
• More air/power at every single throttle position after idle
• Easy Installation

Rev up your vehicle's performance with the Soler Performance Premium Throttle Body, custom-engineered for LS2 Engines. Featuring a calibrated, ported, and modified build, this throttle body promises enhanced airflow and improved engine efficiency.

No drilling is required for installation, and no tuning is needed, making it a hassle-free performance upgrade. Its polished finished surface adds a sleek touch to your engine bay. This product comes fully tested and guarantees proven performance, offering a substantial improvement over the factory setup.

Fits 6.0L V8 LS2 engine

• Cadillac CTS-V - (2006-2007)
• Corvette Base - (2005-2008)
• Pontiac GTO - (2005-2006)

Fitment Notes:

• Must have aftermarket inlet duct/CAI or expandable coupler
• Stock Manifold/Supercharger needs Adapter Kit
• Aftermarket Manifolds or Superchargers ported to at least 102mm do not need Adapter Kit
• Mounts with connector towards the driver side
• Includes Harness 6-pin in-line to 3-pin by 2 lines
• Silver blade calibration

Emissions Disclaimer: This product is NOT CARB legal and CAN NOT ship to California.

Part Number: SE0790-103