Soler Performance Ported Throttle Body, 95mm LS2 2005-2008 Corvette

Features:

• Optimized Active Contours with sonic flow nozzles
• Porting Taper and Upstream Bore with Velocity Stack (Lip & Bore Reduction)
• Greater Discharge Coefficient of Plate/Blade interface
• 16 Ra Microinch, Diamond Polished Surface Finish (Lower Skin Friction)
• Contactless sensor (no wear, longer life)
• Dimpled shaft trailing edge
• Dual hole pattern
• High-efficiency, Manifold Specific Adapter Kit available

Benefits:

• Wide-open throttle flow: 1454 +/- 30 SCFM @ 20.4” of water vacuum [49% increase over 87mm OEM (970 SCFM)]
• Lower weight-to-power ratio at partial throttle, for a more nimble/spirited driving experience
• Linearization and smoothing of the curve for a more predictable response and crisper shifts
• Immediate response right off idling while keeping idling function undisturbed (No Hesitation/Stumble)
• More air/power at every single throttle position after idle. Crucial for starting or expanding power gain modifications
• Does not require tuning. Warranty safe.

Rev up your vehicle's performance with the Soler Performance Premium Throttle Body, custom-engineered for Cadillac, Camaro and Corvette models. Featuring a calibrated, ported, and modified build, this throttle body promises enhanced airflow and improved engine efficiency.

No drilling is required for installation, and no tuning is needed, making it a hassle-free performance upgrade. Its polished finished surface adds a sleek touch to your engine bay. This product comes fully tested and guarantees proven performance, offering a substantial improvement over the factory setup.

Fits 6.0L V8 LS2 engine

• Cadillac CTS-V - (2006-2007)
• Corvette Base - (2005-2008)
• Pontiac GTO - (2005-2006)

Fitment Notes:

• Needs Adapter Kit.
• Mounts with connector towards the driver side.
• Includes Harness 6-pin in-line to 3-pin by 2 lines.
• Silver blade calibration

Emissions Disclaimer: This product is NOT CARB legal and CAN NOT ship to California.

Part Number: SE0790-95ZR